BM17200 In-Ground Brake Tester - Robust and Accurate

The BM17200 roller brake tester has a unique hydraulic load simulation system allowing the operator to raise the roller bed out of the ground.

This brake tester features a large range of options that allows for a customized configuration.

Options

• Robust and long lasting:
  • All steel is of highest quality and hot galvanized.
  • Consists of an integral motorized gear box, two main rollers and a spring loaded sensor roller, all placed in a galvanized steel frame.
  • The wear surfaces of the rollers are based on mesh steel to ensure a long life time and accurate measurements.
  • Can be supplied in a minimum configuration and still allows for later upgrade to all options.
• Easy to use with BM software:
  • Integrated guide.
  • Advanced graphics printout.
  • Diagnostic printout with or without connection to PC/Notebook.
  • Calculation of test results according to the requirements of many national authorities.
  • BM FlexCheck software:
  • Advanced data collection, storing and presentation of test results.
  • Data capture from a complete inspection lane.
  • PDA/smartphone/tablet solution that allows the operator to control and monitor the test results directly on a handheld unit.
• Infrared remote control with an operating distance of 15-25 metres.
• Large and easy-to-read aluminium display with analogue and digital readout of all relevant test data.

  • Integrated guiding system.
  • Large analogue dials showing readings of left and right brake forces.
  • 65 mm high bright digital readouts of other measurement results.
  • Modularly designed so that it can be customized to existing and future demands.
  • Display units are available in daN, kgf or kN.
    
     
• Up to 3 displays can be connected.
   
• Optional cable or radio air/hydraulic pressure system.
   
• Optional automatic axle weighing.
   
• Test of 4×4, 6×4 and 8×6 driven vehicles.
   
• Optional cable or radio pedal force meter.
   
• Conventional axle load simulation with use of slings.
   

The BM17200 roller brake tester is approved by several international authorities i.e. RWTÜV Germany and complies with the ISO standard.

• Hot galvanized subframes can be concreted into the ground before the actual brake tester is installed.
• The subframes ensures easier planning and implementation of installation as well as correct alignment of the brake tester during concreting.
• Can be installed both indoor and outdoor in most environments from -30°C to 60°C and humidity up to 95.
• Optional split bed installation over an inspection pit.

• Normal workshops performing repair of any light or heavy vehicle.
• Preferred model by vehicle inspection bodies, as it can be configured for very high throughput and handle continuous tests of full laden axles.
• Used by various authorities at motorway lay-by stations as part of enforcement schemes.
• Selected by some of the most prestigious vehicle inspection companies worldwide.