BM7110 Brake Testers - Advanced Testing Equipment

The design of the BM7110 roller brake tester is unique as it allows for split bed installation over an inspection pit.

This brake tester features a large range of options that allows for a customized configuration.

Options

• Robust and long lasting:
  • All steel is of highest quality and hot galvanized.
  • Consists of an integral motorized gear box, two main rollers and a spring loaded sensor roller, all placed in a galvanized steel frame.
  • The wear surfaces of the rollers are based on mesh steel to ensure a long life time and accurate measurements.
  • Can be supplied in a minimum configuration and still allows for later upgrade to all options.
  • Prepared for test line expansion including suspension tester, speedometer tester and side slip tester all controlled from the same electronics with results shown on one display.
•  Easy to use with BM software:
  Integrated guide.
  • Advanced graphics printout.
    Diagnostic printout with or without connection to PC/Notebook.
  • Calculation of test results according to the requirements of many national authorities.
  • BM FlexCheck software:
  • Advanced data collection, storing and presentation of test results.
  • Data capture from a complete inspection lane.
•  Infrared remote control with an operating distance of 15-25 metres.
• Cable remote control with a maximum operating distance of 30 metres.
• Large and easy-to-read aluminium display with analogue and digital readout of all relevant test data.
  • Two large dials showing analogue readings of left and right brake forces.
  • 50 mm high bright digital readout of brake force imbalance in %.
  • Optional digital readouts of e.g. ovality, pedal force, weight, efficiency, suspension values, speed and distance values.
  • Display units are available in daN, kgf or kN.
• Pedal force measurement.
• Test of 4×4 driven vehicles.
• Heating package for outdoor installation.
• Motorcycle mode that allows for testing of motorcycles and 3-wheeled vehicles.

The BM7110 roller brake tester is approved by several international authorities i.e. RWTÜV Germany.

• IT system using latest app technology for smartphone and tablet (Windows and Android).

• Split bed roller set makes it possible to install over an inspection pit.

• The display can be mounted either on the wall, saving floor space, or on floor column devices, that are designed so equipment is protected even when floor is cleaned with chemicals. It can also be mounted on a trolley making it easy to move around.

• Completely flush-floor. When roller cover plates are placed on top of the roller bed, the BM7110 becomes one with the workshop floor making it easy to drive over it from any angle.

• Hot galvanized subframes can be concreted into the ground before the actual brake tester is installed.

• The subframes ensures easier planning and implementation of installation as well as correct alignment of the brake tester during concreting.

• Can be installed both indoor and outdoor in most environments from -30ºC to 60°C and humidity up to 95.
  
  
• The special conversation subframes only apply to BM7110.